Metabo Dry-running Sensor Hydrostop Manual do Utilizador descarregar pdf (Página 8)

Hydrostop

2.1

Dry-running sensor Hydrostop

Read instructions carefully before operating this device. Keep instructions for

future reference. 

Safety first!

Electricity and water are a dangerous combination! A current-carrying cable or

electrical appliance in water can lead to a lethal electric shock, as soon as

somebody touches the water. It is therefore absolutely necessary that you

observe the following safety information:

The dry-running sensor’s outer parts (plug, cable

and sensor enclosure) must not come in contact

with water. Position the dry-running sensor so that

 no parts can fall into water;

 no water can run over any of the parts when

the pump starts;

 no parts can become moist by atmospheric

influence;

 any possibly used extension cables do not

come in contact with water either.

Connect the dry-running sensor only to a power source meeting the following requi-

rements:

 Power supply cables and extension cables with a minimum conductor cross sec-

tion of 1.0 mm required by VDE for rubber-sheathed cable type H07 RNF.

 When pumping from swimming pool or garden pond, the pump must be protected

by a residual current device according to VDE 0100, parts 702 and 738.

Check dry-running sensor for any damage before use. Do not use a damaged

device; it cannot be repaired, as the device will no longer be waterproof. Damaged

cables in particular must not be repaired. If the dry-running sensor is faulty, replace

with an intact one.

Drain dry-running sensor completely if there is risk of freezing.

XT0001E1.fm

2Great Britain

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 55 56

Sem comentários

Metabo Dry-running Sensor Hydrostop Manual do Utilizador Página 8